Entretien - Hansgrohe Raindance Select 2jet Showerpipe 271261 Série Instructions De Montage / Mode D'emploi / Garantie

Maintenance
• Should the volume of water
decrease over time, inspect
and clean the filters on the
thermostatic cartridge. After
reassembly, set the high
temperature limit stop and
justify the handle.
• To prolong the life of the
themostatic cartridge,
regularly run it through its full
range of temperatures.
Troubleshooting
Problem
Insufficient water
Crossflow: hot water forced into
cold water supply or vice versa
when mixture is closed
Output temperature does not
correspond with temperature
marked on handle
Safety stop button not operating
Handle hard to turn
Shower or spout dripping
Temperature regulation not possible (new installation) Hot and cold supplies

Entretien

• Si le débit d'eau devait décroî-
tre avec le temps, inspectez
et nettoyez les filtres sur la
cartouche thermostatique.
• Pour prolonger la durée de
vie de la cartouche thermosta-
tique, faites-la fonctionner ré-
gulièrement en utilisant toutes
les températures d'eau.
Possible Cause
Supply pressure inadequate
Cartridge filters dirty
Showerhead or handshower filter dirty
Flow restrictor (A) dirty
Check valves dirty or worn
Handle not justified
Water heater set too low
Button and/or spring are dirty or worn
Cartridge dirty or worn
Volume control cartridge dirty or worn
are reversed
Thermostatic cartridge dirty or worn
Mantenimiento
• Si el volumen del agua
disminuye con el tiempo,
inspeccione y limpie los filtros
del cartucho termostático.
• Para prolongar la vida útil
del cartucho termostático,
hágalo funcionar regular-
mente en todos los rangos de
temperatura.
Solution
Check water pressure
Clean the filters
Clean the filter
Clean the flow restrictor (A)
Clean check valves, replace if
necessary
Justify the handle
Increase the hot water temperature
Clean spring and button, replace if
necessary
Replace cartridge
Clean or replace volume control
cartridge
Correct the plumbing
Replace the thermostatic cartridge
31