Insertion Of Batteries - LaserLiner ThermoInspector Mode D'emploi

1

Insertion of batteries

Open the battery compart-
ment and insert batteries
according to the symbols.
Be sure to pay attention to
polarity.
2
Infrared measurement
The laser is switched on and an infrared measurement can
be performed by pressing the trigger button (8). Measured
values are continually shown by pressing and holding the
trigger button.
3
MIN mode
MIN
MIN mode determines the minimum measured value within
a continuous measurement (keep trigger button pressed).
The measured value is held for 15 seconds (Hold) after the
trigger is released. Pressing the button again will start a new
measurement, reset the MIN value and record the lowest
measured value.
4
MAX mode
MAX
MAX mode determines the maximum measured value within
a continuous measurement (keep trigger button pressed).
The measured value is held for 15 seconds (Hold) after the
trigger is released. Pressing the button again will start a new
measurement, reset the MAX value and record the highest
measured value.
5
LOCK mode
Trigger (8)
LOCK
LOCK mode triggers continuous measurement for a period
of up to 60 minutes. With no mode set, measured values are
shown continually when the trigger button is pressed (keep
trigger button pressed).
6
°C <> °F
Trigger (8)
°C
1x
Trigger (8)
°F
1x
ThermoInspector
Trigger (8)
1x
Trigger (8)
1x
Mode button (3)
1x
button (3)
4x
button (3)
4x
3x
Mode
Mode
Mode button (3)
1x
Mode button (3)
2x
Trigger (8)
1x
Trigger (8)
1x
Trigger (8)
1x
EN
°F
°C
13