Technical Data; Wearing Parts - Kerbl ProPig Mode D'emploi

Care
The grinding body should be always cleaned after use Grinding body and protective aluminium cap should be cleaned with a stiff brush and
water or vinegar. It is also possible to use a conventional lime cleaner for a basic clean-up of both parts. After cleaning lubricate the attachment
of the grinding body with one drop of oil.
Helpful Hint: Do not push the grinding pen against the teeth. This reduces the grinding effect and the
grinding body will be worn unnecessarily. Only grind the teeth at the top so that only the sharp edges will
disappear.

3. Technical data

Revolutions of 20,000 pm for ca. 40 Watt

Wearing Parts

Protective Aluminium Cap
Grinding Body
Charging the storage battery pack:
• The tooth grinder is supplied with electricity via a separate battery pack.
• Should be charged for approx. 3.5 hours before initial operation.
• Remove the storage battery from the device when charging.
• Plug the transformer's appliance connector plug into the charging socket (IN) on the storage battery pack.
• Insert transformer into the socket. The charge control display on the transformer lights up red.
• When the charging process is complete, the charge control display on the transformer lights up green.
• Recommendation: it is possible to extend the life of the storage battery by only recharging it after experiencing a noticeable loss
of grinding power. Full electrical capacity is reached after charging for a period of approximately 3.5 hours.
• The tooth grinder can be used for over 2.5 hours when the storage battery pack is fully charged.
Operation:
• Only connect device to the storage battery pack when switched off!
• Fasten support belt. You can now comfortably attach the storage battery pack to the belt using the attachment clip.
The tooth grinder can then be placed in the specially designed bag.
• Plug the tooth grinder's connecting plug into the socket (OUT) on the storage battery pack.
• Switch on the device using the on/off switch.
• Switch the device off after use.
• Always switch off the device during breaks taken in the grinding process!
CE-symbol / CE-conformity declaration
Albert KERBL GmbH hereby declares that the product / device described in these instructions complies with the fundamental require-
mentsand other relevant stipulations and regulations. The CE mark confirms compliance with the Directives of the European Union.
The declaration of conformity can be viewed by visiting http://www.kerbl.com/artikel22655
Electronic scrap
Disposing of this device after its service life is the responsibility of the operator. Please consult the valid national regulations. The
device must not be disposed of in household waste. In accordance with the stipulations of the EU Directive on the Disposal of
Electrical and Electronic Devices, the device can be disposed of free of charge at the local waste collection or recycling centre.
Alternatively, it can be returned to retailers who offer a collection service. The proper disposal helps to ensure environmental
protection and prevents any adverse effects on human health and the environment.
Ref. No. 22878
Ref. No. 22913
7