Assembly Of The Mounts And Wheels; Operation - Haverland NYEC Série Manuel D'utilisation

* Place the appliance in a vertical position to allow to read the package and proceed to
unpack the heater.
* Remove the mounts, wheels and one clamp from the polystyrene protection, leaving
the protection placed on the appliance.
* Place the appliance in an inverted position using the polystyrene as a support base.
clamp
* Connect the appliance to the socket (220 - 240 V - 50 Hz) with the switch on the zero
position.
* Turn the button of the thermostat to position maximum.
* Put the switch on position 1. Minimum power will be obtained.
* Put the switch on position 2. Medium power will be obtained.
* Put the switch on position 3. Maximum power will be obtained.
To determine the desired temperature, put the thermostat button on maximum. Once a
comfortable temperature has been obtained, turn the button slowly in an anticlockwise
direction until the light turn off. This thermal control device will maintain the temperature
constant.
8

ASSEMBLY OF THE MOUNTS AND WHEELS

1
KIT
3
2
4

OPERATION