Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The anti-frost temperature (7 ºC) cannot
be changed.
3.4 Comfort, Anti- frost and Economy
Temperatures
The thermostat has three pre-adjusted temperatures.
The operating temperature is shown in colours light
indicator 2:
The default comfort temperature adjustment (when
the room is occupied) is 20 ºC.
The default economy temperature adjustment (when
the room is not occupied or someone is sleeping) is
16 ºC.
The default anti-frost temperature adjustment (when
the occupant is absent from the room for more than
twelve hours) is 7 ºC.
Comfort and economy temperatures may be modified
(the anti-frost temperature is fixed):
1. To change the comfort and economy temperatures,
the heater must be in MANUAL MODE (see point
3.2).
2. Select the temperature to be changed, comfort,
anti-freezing or economy, pressing key
1.
Red pilot = Comfort
2.
Blue pilot = Anti-frost
3.
Green pilot= Economy
3. Press key
. the adjusted temperature will
appear flashing for several seconds.
4. Press either of buttons
once to change the adjusted temperature.
NOTES :
• The comfort temperature range is from 18 to 28 ºC.
• The maximum economy temperature is 18 ºC.
2
1.
Red pilot = Comfort
2.
Blue pilot = Anti-frost
3.
Green pilot= Economy
.
and
more than
• The economy temperature can NEVER be higher
than the comfort temperature.
• The economy temperature is always 4 ºC less than
the assigned comfort temperature.
3.5 "Open Windows" Function
This function is activated when there is a sudden drop
of temperature in the room.
When this function is activated (indicator 11, point
1.3), the radiator will switch off, avoiding unnecessary
power consumption.
By closing the window, the radiator will detect a rise in
temperature and this function will be deactivated.
The radiator will switch on again to the mode it was
before the switch-off.
This function is pre-set from the factory. It
can be activated or deactivated by the user.
1. Set the radiator on "Standby" mode by pressing the
"Standby" button.
2. Press the
and
two lines will be displayed indicating that the function
is activated.
3. To deactivate the function please press again the
and
buttons.
A single line will be displayed. Wait a few seconds for
the radiator to return to the "Standby" mode. If you
wish to switch on the radiator, press the "standby"
button
.
3.6 "Keypad Block" Function
The keypad may be blocked and
unblocked by simultaneously
pressing keys
and
A light spot appears on the right
side of the screen .
buttons simultaneously,
.
IMPORTANT:
"Lo"
If
appears on the screen
when we press any button, the
control panel is locked.
IMPORTANT:
If two light spots appear on
the screen, the keypad is
locked in standby mode.
Page 33
Publicité
Table des Matières
