Adjusting The Position Of An Existing Start Id - Sony PCM-R500 Mode D'emploi

Writing Sub Codes
When writing a start ID
0.3 sec
Movement with each
press of REW 0
When writing a skip ID
0.3 sec
Movement with each
press of REW 0
The time in the display shows the shift in position
from the time the REHEARSAL button was
pressed.
Positioning Start ID
After pressing FF ) twice
After pressing REW 0 twice
3
Press WRITE of the corresponding ID to write the
ID.
"ID WRITE" appears for a few seconds and the ID
is written on the tape at the selected position.
• Start IDs are 9 seconds long starting from the
beginning of the repeated portion.
• Skip IDs are 1 second long starting from the end
of the repeated portion.
Newly written IDs positioned by the Rehearsal
function
n Tape direction
Start ID
Skip ID
22 EN
Position where the
REHEARSAL button
is pressed in step 1.
↓
3 seconds
Repeated portion
Movement with each press
of FF )
0.3 sec
Position where the
REHEARSAL button
is pressed in step 1.
↓
3 seconds
Repeated portion
Movement with each press
of FF )
0.3 sec
0 6 .6 S
START ID
S
0 6 .6
START ID
Repeated portion
9 seconds
1 second
Adjusting the Position of an
Existing Start ID
You can adjust the position of previously recorded
start IDs.
START ID REHEARSAL
POWER
Ø ON ø OFF
REMOTE
WIRED OFF WIRELESS
AMS
PREVIOUS
=
PHONE LEVEL
• START ID OPEN/CLOSE
AUTO REHEARSAL WRITE ERASE REPEAT LOCATE
6
MIN MAX
SKIP ID
PHONES RENUMBER REHEARSAL WRITE ERASE SKIP PLAY MARK
1
During playback, press START ID REHEARSAL
when you arrive at the existing start ID you want
to reposition.
The deck rewinds to the beginning of start ID and
the Rehearsal function repeats a 3-second portion.
2
Do the steps 2 and 3 of "Accurate positioning of
sub codes" on pages 21 and 22.
You can move the start ID to a maximum extent of
about 2 seconds (4 seconds in long-play mode) in
either direction from its original position.
Notes
• Start IDs written within 10 seconds from the end of the
tape may be difficult or impossible to move.
• Existing skip IDs cannot be moved.
INPUT
ANALOG DIGITAL
MODE
ANALOG INPUT
UNBALANCE BALANCE
COUNTER RESET
REC MODE
STANDARD LONG
MARGIN RESET
48k 44.1k
SBM
OFF ON
SHUTTLE DATA
NEXT REW FF REC MUTE MENU
REC LEVEL
+ 0 ) R r CH-1(L)
•
STOP PLAY PAUSE REC
SET
0 10
p ( P r
CH-2(R)
•
0 10
3-859-278-11(1)