Fitting Instructions - gdw 1608 Mode D'emploi

Lada 1118
10/2006 - ....
Ref. 1608

Fitting instructions

1. Remove the exhaust out of the filling up rubber at the back of the vehicle.
2. Place the mounting piece (1) with points (A) and (B) against the inside of the chassis beam on the left
side of the vehicle on the provided screw-thread holes. Insert the bolts and the washers but do not tighten
yet.
3. Place afterwards the tow bar with points (A) and (B) against the inside of the right chassis beam and with
points (C) against the cross-beam at the back of the vehicle on the provided screw-thread holes. Points
(D) and (E) match the drillings in the left side plate of the tow bar. Insert the bolts and the washers and
tighten everything firmly (see tension).
4. Hang the exhaust back.
5. Assemble the ball against the underside of the tube and place plate (2) on top of the tube. Insert the bolts
and screw those firmly on together with the socket plate and the security shackle (see tension).
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
+ 1117 Combi
2008-....