Table des Matières
Publicité
Charger Belt
4. Place the Charger Belt around your body so
that the power button and mesh fabric are
facing out. Affix the adjustable straps so that
the Belt is slightly loose at first. In order to
properly use the Charger Belt, both of the
straps must go through the Belt Loop. See
Figure 2.
5. Position the Charger over the Stimulator. When
the Charger is aligned over the Stimulator, the
beeping will stop. For best charging results,
make sure the Charger is well ventilated
4
and centered over the Stimulator. See Figure
3
5 for proper alignment of the Charger. Please
refer to the Patient System Handbook for
instructions on how to use the Charger.
6. Once the Charger is properly positioned,
tighten the Charger Belt to secure the Charger
2
1
in place. Be careful to maintain the Charger's
alignment over the Stimulator as you tighten
the Belt. Take care to not overtighten the Belt,
which may result in discomfort or accidental
movement of the Charger.
Note: Wearing the Charger Belt over loose
fitting clothes may result in more frequent
movement of the Charger. For best charging
results, occasionally check the Charger
to make sure that it is centered over the
Stimulator. If the Charger is not centered
over the Stimulator, charging time may
increase. If it moves significantly out of
alignment, it will start beeping again. See
Figure 4 for an example of poor alignment of
the Charger.
Charger Handbook
91000594-03
2 of 79
Figure 4. Poor alignment of Charger (outlined in
grey) over Stimulator (dotted line).
Readjust the Charger Belt to center the
Charger over the Stimulator to ensure best
performance. See Figure 5 for an example of
ideal alignment of the Charger.
Figure 5. Ideal alignment of Charger (outlined in
grey) over Stimulator (dotted line).
Completing Charging
7. When finished charging, unfasten the Charger
Belt and then remove the Charger from the
pouch. Turn off the Charger by pressing the
power button and return the Charger to the
Base Station.
Publicité
Table des Matières
