Bottom Mount Models (Only) - Jenn-Air JPK36BNXESS Instructions D'installation

Bottom Mount Models (only)

IMPORTANT: For Side by Side models, skip this section and go to
"Install Door Panels."
1.
Loosen bracket screws.
2.
Slide panel onto drawer.
Retighten the four screws on each side attaching the bracket to the
drawer panel.
3.
Install panel to drawer.
Using the Phillips-head, flat screws, fasten the panel brackets to the
drawer.
4.
Align panel.
A
B
A. Drawer panel
B. Drawer panel bracket
To allow for later adjustment of the panel, do not fully tighten the
screws attaching the bracket to the drawer.
IMPORTANT: When you have completed installing all the panels
check for alignment. The drawer panel will move up or down to align.
Completely tighten the screws.
IMPORTANT: 36" Bottom Mount Model (only)
The hardware installed on the door panels fits refrigerator doors that
have hinges on the right-hand side. If your refrigerator door has the
hinges on the left-hand side, you must move the mounting brackets
and the shoulder washers.
To modify the door panel for a left-hand swing door:
1.
Move mounting bracket.
A. Mounting bracket.
A
5