Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.
Mount panel to door.
Align the two shoulder washers, on the back of the door panel, with
the "J" slots on the side of the refrigerator door.
5.
Lower panel onto pins.
A. Door panel
B. Panel top bracket
Slide the panel onto the door, and lower the panel bracket down onto
the adjustment pins at the top of the door.
6.
Repeat.
French door and Side by Side models, repeat steps 2 through 5 to
install the second door panel.
Install Top Grille Panel
1.
Hook panel brackets onto
mounting pins.
A
B
C
C. Adjustment pins
Holding the panel at an angle, hook the brackets onto the mounting
bolts extending from the top of the refrigerator. Then, push the bottom
of the grille panel forward until the bracket snaps into place.
2.
Align panel.
Loosen the mounting bracket screws and move the brackets up or
down to achieve the proper spacing between the panels.
Door Swing Adjustment
1.
Open door to less than 90°. Insert
door stop pin.
A. Door stop pin hole
If the standard 110° door swing is too wide, install the door stop pin to
allow for a maximum 90° door swing. Insert the door stop pin into the
top hinge in the hole shown. Use a ⁵⁄₃₂" hex key, to tighten door stop
pin.
Panel Adjustment
1.
Measure gaps between panels.
A
A. Installation block
(optional)
(optional)
A
7
Publicité
Table des Matières
