Dmx-512 Connection / Connection Between Fixtures - Futurelight PHS-1200E Mode D'emploi

(1) Omega-holders
(2) Clamp
(3) Safety-rope
(4) Quick-lock fastener

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Screw one clamp each via a M12 screw and nut onto the Omega-holders.
Insert the quick-lock fasteners of the first Omega-holder into the respective
holes on the bottom of the device. Tighten the quick-lock fasteners fully
clockwise. Install the second Omega-holder.
the fixtures will not work at all, or will not work properly.
47/130 00026924.DOC; Version 1.6