Function Mode; Information - Futurelight PHS-1200E Mode D'emploi

Select Programs
Edit program
Edit scenes
Auto scenes Rec.

Function Mode

DMX address setting
With this function, you can adjust the desired DMX-address via the Control Board.
• Select "Set DMX address" via the encoder.
• Press the Enter-button, adjust the DMX address by turning the encoder.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order return to the main menu.
Display the DMX 512 value of each channel
With this function you can display the DMX 512 value of each channel. The display automatically shows the
channel with a value changing.
Slave setting
With this function, you can define the device as slave. You can choose one of three different Slave
programs. For further information see „Edit Program" - „Select Programs"
Auto program
With this function, you can run the internal program. You can select the desired program under "Select
program". You can set the number of steps under "Edit program". You can edit the individual scenes under
"Edit scenes". With this function, you can run the individual scenes either automatically, i.e. with the adjusted
Step-Time. The selection "Alone" means Stand Alone-mode and "Master" that the device is defined as
master.
Music control
With this function, you can run the internal program sound-controlled. The selection "Alone" means Stand
Alone-mode and "Master" that the device is defined as master.

Information

Time information
Individual run time
With this function, you can display the temporary running time of the device from the last power on. The
display shows "XXXX", "X" stands for the number of hours. The counter is reset after turning the device off.
Total run time
With this function, you can display the running time of the device. The display shows "XXXX", "X" stands for
the number of hours.
Total lamp on time
With this function, you can display the running time of the lamp. The display shows "XXXX", "X" stands for
the number of hours.
Auto Pro Part 1
Auto Pro Part 2
Auto Pro Part 3
Program 1
:
Program 10
Edit scene 001
:
Edit scene 250
XXX~XXX
57/130
Progr. 1- 10 Program 1
Progr. 1- 10 Program 2
Progr. 1- 10 Program 3
Program Test ("Step XX")
Start step Start
step=
xxx
End step End
step=xxx
Pan,Tilt, ...
Pan=XXX
--Scene
TIME=XX.
Time--
XS
Input by
outside
00026924.DOC; Version 1.6
Select programs to be
run
Testing program
Program in loop
Save and exit
Save and
automatically return
manual scenes edit
Automat. scenes rec