Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Wireless DMX
For wireless data transmission you need a DMX-controller, a wireless sender and a wireless receiver or
devices with wireless receiver, respectively.
If a device with wireless receiver is connected with a DMX-controller via cable, the device will be controlled
by the cabled controller and not by the wireless transmitter.
Please note: Never connect a cabled controller if the device with wireless receiver is controlled by the
wireless transmitter! Otherwise danger of interferences.
The wireless receiver has an internal memory function. If the device is switched off and on again, the
receiver automatically logs into the transmitter.
Meaning of the LEDs and their colours
Wireless sender status-LED
Red/green flashes rapidly: Login-mode, every free wireless receiver is logging into the wireless sender.
Green permanently lit: the DMX-signal is present and transmitted.
Red/green flashes slowly: no DMX-signal, the radio link is being held.
Wireless receiver sender status-LED
Red permanently lit: not logged into a wireless sender (free).
Red/green flashes rapidly: Login-mode, the wireless receiver is logging into the wireless sender.
Green permanently lit: The wireless receiver is logged into the wireless sender. The DMX-signal is present
and received.
Red/green flashes slowly: no DMX-signal, the radio link is being held.
Installation of a wireless DMX-system
1. Connect the DMX-controller with the wireless sender.
2. Switch on the DMX-controller, den the wireless sender and the wireless receiver or the devices with
wireless receiver, respectively.
3. Press and hold the sender's Function-button for less than 3 seconds. During the Login-mode, the sender's
and receiver's red/green LEDs flash rapidly for approx. 5-10 seconds. As soon as the DMX-signal is
transmitted, the sender's and receiver's green LED is permently lit. If there is no DMX-signal, the sender's
and receiver's red/green LEDs flash slowly.
4. Control the device via your DMX-controller.
Log out one wireless receiver
The procedure of logging out one wireless receiver depends on the respective device. The FUTURELIGHT
projectors with wireless receiver are logged out via the Control Board, menu Set-WDMX-Rest. The
FUTURELIGHT WDR-1 wireless receiver logs out by pressing and holding the receiver's Function-button for
more than 5 seconds. As soon as the wireless receiver is logged out, the receiver's red LED is permently lit.
Log out all wireless receivers from the sender
Press and hold the sender's Function-button for at least 5 seconds. As soon as the wireless receivers are
logged out, the receiver's red LED is permently lit.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the PHS-1200E will respond to the controller.
If you set, for example, the address to channel 27, the PHS-1200E will use the channel 27 to 52 for control.
Please, be sure that you don't have any overlapping channels in order to control each PHS-1200E correctly
and independently from any other fixture on the DMX-chain.
If several PHS-1200E are addressed similarly, they will work synchronically.
Trun the encoder for setting the desired starting address. Now you can start operating the PHS-1200E via
your lighting controller.
49/130
00026924.DOC; Version 1.6
Publicité
Table des Matières
