switel DC68 Série Mode D'emploi page 109

Problems and solutions
Problems
No telephone calls possible
No connection to base station
possible
Connection is disturbed or cut off
The system no longer responds
The batteries are empty within a
short time
The caller number display (CLIP)
does not function
In Case of Problems
Solutions
− The telephone is not connected properly or is
defective. Only use the telephone connection
cable supplied.
− Test whether the telephone connection is in
order by using another telephone.
− The power adaptor plug is not plugged in or
there is a complete power failure.
− The rechargeable batteries are empty or de-
fective.
− The handset is too far from the base station.
− The wrong dialling mode is set; . Page 99.
− Check that the handset has been registered on
the base station with the correct PIN code;
. Page 99.
− The handset is too far from the base station.
− The base station is in an unsuitable location.
− Reset all the functions to their default settings;
. Page 99.
− Disconnect the power adapter plug briefly from
the power socket.
− The batteries are empty or defective.
− Place the handset in the base station properly.
Clean the contact surfaces on the handset and
base station with a soft, dry cloth.
− Place the handset in the base station for
16 hours.
− The caller number display (CLIP) is a supple-
mentary service offered by your telephone net-
work provider. Contact your network provider
for further information.
− The caller has suppressed the transmission of
their phone number.
109