Gardeo GDCBT34-4IN1 Mode D'emploi page 28

Fig. 1-Driving unit
Fig. 5Brush cutter
6.7 set of petrol multi-purpose tools: hedge trimmer
Structural Group 7 Delivered parts and
accessories
Fig. 1-Driving unit
Fig. 2- Extension
Fig. 4- Hedge trimmer
6.8 set of petrol multi-purpose tools: Pruning saw
Structural Group 8 Delivered parts and
accessories
Fig. 1-Driving unit
Fig. 2- Extension
Fig. 3- Pruning saw
6.9 set of petrol multi-purpose tools:Extension rod
Structural Group 9 Delivered parts and accessories
Fig. 2- Extension
6.10 Shoulder harness Assembly
Structural Group 10
6.11Fuel information
Assembly
Refueling:
For air-cooled 2-stroke engines, mix unleaded petrol well with a branded oil at a ratio of 1:40. Meaning that
0.2 liter oil has to be added in 5 liters of petrol. .Tip: Always prepare 1 liter of the mix at a time because the mix
turns unusable after prolonged storage. .
6.12 Initial Operation Safety Instructions
Warning ! Before putting the set in operation, check it to see that the condition is safe with regard to
operation. Do not switch the machine on, if in doubt!
In emergency switch the tool off and put off the tool from your body quickly!
Keep a watch on the points shown below:
All the integrated tools must run freely .Before starting the set, make sure that the integrated tools are fitted on
Assembly
the driving unit correctly and that the moving parts of the machine run freely. .
Warning ! If in doubt, require assistance of an expert from the authorised servicing centre . Laic advice may
being started. Always have your hand on the additional handle lightly . Always use the machine with the carrying
strap supplied. Hld one hand on the engine handle and the other one in the axle handle.
Always hold the unit at an appropriate safe distance from the body and take a stable posture. .
Always use a face shield .
Use the machine at daylight only.
Do not use the machine in rain or on wet grass
Check the machine after a stroke for possible damages and have it repaired if necessary .
Do not use the machine if the protection devices are damaged or installed incorrectly .
Make sure that the engine vents are free of any dirt and remnants .
In the course of work procedure, make sure that no persons or animals are standing within 10 m
diameter . Switch the machine off immediately if anybody, children in the first place, enter the reach of
machine.
Using the set, stones or other parts may be thrown away and may cause serious injuries.
Do not get close to moving parts (where they have cutting devices – integrated bush clipper)
Before using the tool, the work area must be cleared from any stone, branches and other solid material
After the cutting fibre is extended, maximum attention is required (brush cutter) . Having accomplished the
procedure reclaim the correct working position before the machine is out in operation again. .
Do not use metal cutting coils. .
Pay attention to the machine running for another five seconds after relieving the switch. .
55
Delivered parts
accessories
Fig. 1-Driving unit
Cirrect assembly of integrated tools .
Easy run of all the switches
Safe installation of the ignition plug . When the plug is loose, sparkles may be generated and the flowing mix
of fuel and air may get ignited.
Make sure that the handle is clean to conduct the set safely. Before starting the machine, all the safety and
protection devices have to be fitted correctly at places. .
CAUTION! Held your hands and legs out of the reach of the integrated tool, mainly when the machine is
and
56