Gardeo GDCBT34-4IN1 Mode D'emploi page 24

of the machine.
Stop the engine before: 1) cleaning or when cleaning a blockage 2) checking, maintenance or working on the
machine 3) when adjusting the working position of the cutting device.
HANDLING FUEL
1. The engine is designed to run on a mixed fuel, which contains highly flammable gasoline. Never store cans of
fuel or refill the tank of the unit in any place where there is a boiler, stove, wood fire, electrical sparks, welding
sparks, or any other source of heat or fire which might ignite the fuel.
2. Never smoke while operating the unit or refilling its fuel tank. 3. When refilling the tank, always turn off the
engine and allow it to cool down. Take a careful look around to make sure that there are no sparks or open
flames anywhere nearby before refueling.
4. Wipe spilled fuel completely using a dry rag if any fuel spillage occurs during refueling.
5. After refueling, screw the fuel cap back tightly onto the fuel tank and then carry the unit to a spot 3 m or more
away from where it was refueled before turning on the engine
Warning! Use of other attachment head, accessories and superstructure parts that are expressly forbidden,
which may result in a threat to persons and property. .
The machine should not be used for other than intended purposes. Any deviation from the purpose shall be
considered an unauthorized use. Only the user, and never the manufacturer, shall be held liable for any material
and personal damage resulting from such an unauthorized use.
The manufacturer shall not perform any warranties if the machines manufactured by it are altered or used in an
unauthorized manner and if damage is inflicted in result.
CAUTION!
Even if the machine is professionally used, there is always residual risk that is impossible to exclude. It
is the type and design of the machine, which potential risks may be derived from as follows:
Contact with uncovered mowing head (laceration).
Reaching the running scythe (laceration) .
Hearing impairment, if proper ear protection is not used .
Dust/gas formation harmful to the health if the machined is used in confined areas (nausea).
Must assemble the extension when use the pruning saw and hedge trimmer。
2.1 Emergency Action
Apply the first aid adequate to the injury and get qualified medical assistance as quickly as possible. Protect the
injured person from more accidents and calm him/her down.
2.2 Signs on Unit
SYMBOLS ON THE MACHINE
For safe operation and maintenance, symbols are carved in relief on the machine. According to these
indications, please be careful not to make a mistake.
The port to refuel the "MIX GASOLINE"
Position: FUEL TANK CAP
The direction to close the choke
Position: AIR CLEANER COVER
The direction to open the choke
Position: AIR CLEANER COVER
If you turn the rod by screwdriver follow the arrow to the
"MAX" position, the chain oil flow more, and if you turn to the "MIN" position, less.
Position: Bottom of the TRANSMISSION
2.3 Assigned Use
Meaning of Symbols
Symbols shown below are used throughout this manual and/or on the unit :
Product Safety
Product compliance with
respective EU standards
Bans:
No fire, no unprotected
source of light, no
smoking
Warning
Warning/caution Beware of
ground
obstacle
Keep in mind Keep at least
that the cutting 15 m as safe
head cannot distance from
come into any third
contact with person when
alien matter at working.
its start and in
the working
operation.
47
Beware of falling Beware if health Keep
objects hazardous bystanders
gases away at min.
15m away
Cutting blade Nylon cutting The machine
max. rotational head rotational shall not be
speed speed used in any
position that
cause any part
to come within
10 m of
overhead
electrical lines.
48