Protocol Commands - Blackmagic Design Duplicator 4K Manuel D'utilisation Et D'installation

Protocol Commands

Command
help or ?
remote
remote: enable: true
remote: enable: false
remote: override: true
remote: override: false
quit
ping
record
record: append: true
stop
commands
notify
notify: transport: true
notify: transport: false
notify: slot: true
notify: slot: false
notify: remote: true
notify: remote: false
notify: configuration: true
notify: configuration: false
slot info: slot id: {slot ID}
transport info
configuration
configuration: video input:
{"SDI", "optical"}
watchdog: period: {seconds}
Using XML
While you can use the Terminal to talk to HyperDeck, if you are writing software you can use XML to
confirm the existence of a specific command based on the firmware of the HyperDeck you are
communicating with. This helps your software user interface adjust to the capabilities of the specific
HyperDeck model and software version.
Command Description
Provides help text with all commands and parameters.
Queries the state of HyperDeck's remote control mode.
Enables remote control.
disables remote control.
Turns remote override on.
Turns remote override off.
Disconnects HyperDeck server.
Determines HyperDeck server is responding.
Starts recording.
Starts appended recording.
Stops playback or recording.
Lists all supported commands in an XML format.
Queries the current state of all notifications.
Enables transport notifications.
Disables transport notifications.
Enables slot notifications.
Disables slot notifications.
Enables remote notifications.
Disables remote notifications.
Enables configuration notifications.
Disables configuration notifications.
Provides information about a specified slot.
Provides information for the state of the transport.
Queries the current configuration.
Configures video input.
Configures the watchdog.
Contrôle à distance via Ethernet 91