System Menu - Sony BRC-H900 Mode D'emploi

Setting range of TILT DOWN/TILT UP
89°
±0°
–29°
END (–30°)
Notes
• Before storing the camera position in a preset memory,
perform the PAN-TILT LIMIT setting. If the camera
position is not within the range of the PAN-TILT
LIMIT setting, you cannot store the camera position in
the preset memory.
• The PAN-TILT LIMIT setting is reset to the factory
setting when you change IMG FLIP of the SYSTEM
menu.
• Before storing the camera position in a preset memory,
install the camera suitably and fix the camera securely.
If you change the installation of the camera after
presetting, differences may arise on the preset.
RAMP CURVE
Select the panning and tilting speed acceleration or
reduction mode when the preset panning and tilting
operation is recalled.
MODE1: Panning/tilting speed accelerates or reduces
sharper than MODE2.
MODE2: Panning/tilting speed accelerates or reduces
with standard response.
UP END (90°)

SYSTEM Menu

< S Y S T E M >
I R R E C E I V E
I M G F L I P
P A N R E V E R S E
T I L T R E V E R S E
> D I S P L A Y I N F O
S Y N C M A S T E R
H P H A S E
H P H A S E F I N E
S T E A D Y S H O T
C O L O R B A R
T A L L Y M O D E
V E R S I O N
IR RECEIVE (infrared signal reception)
When it is set to OFF, the camera does not receive the
signal from the supplied Remote Commander.
Be sure to keep it ON when you use the supplied Remote
Commander.
Note
You cannot set IR RECEIVE to OFF when you operate
the menu using the supplied Remote Commander. To set
it to OFF, use the RM-BR300 Remote Control Unit (not
supplied) or the VISCA command.
IMG FLIP (image flip)
Set IMG FLIP to ON to rotate the camera image
supplied from the RGB/COMPONENT,
S VIDEO, T VIDEO, and SDI OUT connector
and the connector on the optional Interface Card inserted
into the card slot upside down and to reverse the
direction of the camera movement by pan/tilt operation.
Set PAN REVERSE to ON to reverse the horizontal
movement of the camera image.
Set TILT REVERSE to ON to reverse the vertical
movement of the camera image.
When you set IMG FLIP to ON, "Please restart system!"
appears. Turn off the power of the camera, then turn it on
again.
Notes
• Regardless of the IMG FLIP ON/OFF setting, images
shot by the camera are accumulated for the vertical
synchronization period and output from the
S VIDEO, T VIDEO, and SDI
COMPONENT,
OUT connector of the camera and the connector on the
optional Interface Card inserted into the card slot.
• When you set IMG FLIP to ON, turn off the camera,
then turn it on again, PAN REVERSE and TILT
REVERSE will be set to ON. When you set IMG FLIP
to OFF, turn the power off, then on again, PAN
REVERSE and TILT REVERSE will be set to OFF.
O N
O F F
O F F
O F F
O N
H D
0 3
0
O F F
O F F
L O W
1 . 0 0
RGB/
39
GB
SYSTEM Menu