Comet DSG-10 EX Mode D'emploi page 24

EN
control panel board.
5) ⑬ If the water level in the boiler is already
correct, the thermoregulator will indicate
the temperature value previously set by the
operator after approx. 7-10 minutes. At this
point, the steam gun can be used.
6) ⑬ If the display show H2O and it flashes and
an acoustic alarm is heard, it means that there
is no water in the tank. Fill the tank (see "Filling
the tanks with water and detergent").
Machine stop
At the end of the work shift, stop the machine in the
following way:
1) ⑤ Switch off : BOILER START push-button
2) ⑥ Switch off : GUN START push-button.
3) ① Turn the main switch on the control panel
board to OFF.
4) Unplug the machine.
WARNINGS
- In order to suddenly stop the machine at any
time, turn the main switch on the control panel
to OFF.
- During the machine functioning, it is strictly
forbidden to remove the safety devices
assembled by the Builder on the machine in
order to protect the operator while performing
his tasks.
- Only skilled and qualified operators must use
the machine.
- To move the machine inside the industrial area,
always use the special handle.
Never use the power cable or the gun cable to
move it.
- Never direct the steam gun towards people
and objects made of plastic, crystal or other
delicate materials that may melt or deteriorate
at 180°C.
- Never leave the machine unattended.
- Always de-energise the machine before filling
the tanks.
- The machine cannot work if distilled water is
used to fill the tank
MAINTENANCE AND
SERVICING
Precautions for the machine maintenance
Before any maintenance activity, it is necessary to:
- De-energise the machine
- Apply a panel warning that the machine
maintenance is underway.
Maintenance interventions
see: "ROUTINE MAINTENANCE TABLE"
WARNINGS
A good maintenance is a determining factor
for a longer life of the machine in the best
functioning and performance conditions in
order to assure the safety conditions provided
by the Builder.
- Before any maintenance or replacement
activity, remember to:
- stop the machine (MAIN SWITCH turned to
OFF)
- unplug it.
- Only skilled operators, familiar with the
technology used on the machine must carry
out all the maintenance, replacement or
servicing activities described in this handbook.
Machine visual inspection
In order to assure a correct functioning and prevent
troubles, periodical visual inspections of the
machine and its moving parts are recommended.
Such inspections must be carried out after de-
energising the machine.
Particularly make sure that there are no anomalous
contacts between the elements and that the fixing
systems are not loosened.
Machine general cleaning
Once a week, remove all the dust from the machine
using compressed air.
Clean the machine body externally with suitable
detergents.
WARNINGS
Always wear protective gloves when cleaning the
machine.
24