Weller Pyropen WP 60 Mode D'emploi page 21

How to change ejector unit
Ejector unit
Trouble shooting
Trouble:
Does not ignite
Tip does not heat
If your device ceases to function correctly, take it to your nearest authorised customer
service centre www.weller-tools.com
Change ejector unit when gas does not
flow. Pull ejector unit upward, then the unit
will come off. Insert new ejector unit and
push the unit down till fixed.
Problem cause:
1. Empty gas
2. Ejector unit breakage,
clogging, or used up
3. Gas pressure too
high or too low
1. Used up catalyst
2. Insufficient gas
pressure
Problem cause:
1. Empty gas
2. Ejector unit
breakage, clogging
or used up
3. Gas pressure too
high or too low
1. Used up catalyst
2. Insufficient gas
pressure
19