Rehau RAUTOOL XPAND QC Mode D'emploi page 29

2 x
20 s
20 s/2 Hz
20 s
20 s/2 Hz
20 s/5 Hz
1 x
3 x 3 x
Self-test! When the battery is inserted, the light-emitting diode flashes
a few times. This means that the electronic control is
performing its self-test satisfactorily.
Attention! Wait approx. 30 seconds between removing
the empty battery and inserting a charged one so that the
self-test can be carried out.
Battery is flat! If the diode displays a steady light for about 20 seconds
after a work operation, this means that the battery is empty
and needs to be charged.
Service! If the diode flashes for about 20 seconds upon completion
of a work operation, this means that maintenance need
s to be carried out (after 20,000 joints). The tool should be
sent to the REHAU service center as soon as possible.
Battery is flat! If the LED lights up for 20 seconds and then flashes, this
means that the battery is flat and also that maintenance
is due.
Overheating! If the diode flashes quickly for about 20 seconds, this means
that the tool is overheated.
Warning! If the light-emitting diode flashes once and emits a signal tone
Pressing force! during the compression process, either the necessary
pressing force was not reached or the pressing process
was manually interrupted. The joint made in the compression
process may not have been created properly and must
be inspected.
Warning!
If the light-emitting diodes and the workspace lighting
Serious flash three times and if a signal tone is emitted at the
malfunction!
same time during the compression process, there is a
serious malfunction. The pressing force is not being reached
when the motor is running. The joint made in this
compression process may not have been created properly
and must be inspected! The tool should be sent to the
REHAU service center for repair as soon as possible. Should this
malfunction occur three times in succession, the device will
switch to malfunction and will need to be sent to the
REHAU service center for repair.
EN
29