Safety Warnings - Rehau RAUTOOL XPAND QC Mode D'emploi

SAFETY WARNINGS

The tool is intended to be used with all REHAU
expander heads in the range of 12 (16) - 40 mm .
This includes the quick release and the older
screw type .
Read all safety warnings and assembly
instructions before using the tool .
Follow these operating instructions and always
keep the safety warnings with the tool .
In addition to the operating instructions, always
observe generally applicable statutory and other
binding regulations relating to the prevention of
and protection against accidents .
General safety warnings:
1. Keep your workplace clean and free of
obstructions. Make sure there is always sufficient
light.
2. Keep children, pets and unauthorised persons
away from the place at which you are working.
3. Wear suitable safety clothing. Do not wear loosely
fitting clothes or jewellery! They may get caught in
moving parts. Wear a hairnet if you have long hair.
Use goggles.
4. Do not touch moving parts (risk of trapping
fingers)!.
5. Be alert! Only use the tool if you have received
instructions in using it.
6. Keep your tools in a safe place. When not in use,
tools should be kept in dry, closed rooms out of
the reach of children.
7. The tool is only suitable for making REHAU
Everlock joints. Do not use the tool for any other
purposes!
8. Only operate the tool with original REHAU parts
and accessories.
9. Maintenance and repair work should be done only
in a service center authorised by REHAU. We will
not be responsible for any work performed by an
unauthorised person. The addresses of authorised
service centers can be obtained from your REHAU
sales office.
General tool-specific safety warnings:
1. Keep the tool, the batteries and the charger away
from moisture, extreme heat, oil and solvents.
The charger is only intended for use in dry, indoor
rooms. It must not be used outdoors.
2. Never operate the tool in an environment presen-
ting the risk of fire or explosion! Do not expose the
tool to flames or extreme heat!
3. Before use, examine the tool and accessories for
damage or defects (for example, cracks in the
cable insulation, oil leaks from the tool, damage
or visible wear of the expander mandrel or the
basic tool itself). Check whether the moving parts
are in proper working order, that they are not
jammed and that parts are not damaged. All parts
must be correctly assembled and satisfy all of the
conditions to ensure proper tool operation.
EN
21