Installation Procedure - Toto TB100DF Manuel D'installation Et D'utilisation

1) Install the hot and cold water supply
nipples (1/2" NPT male, not sup-
plied) according to the provided
diagram.
IM PORTANT: Correct positioning of
the supply lines is critical to ensure
proper installation.
Thoroughly flush all supply lines
and shut off the water supply before
proceeding with installation.
2) Loosen the set screw on the hand-
shower bracket and slide it up the leg
of the tub filler assembly, followed by
the escutcheons.
Loosely tighten the set screw to hold
the handshower in place during the
rest of the assembly.
3) Thread a locknut onto each leg of the tub
filler assembly until it stops, followed by a
mounting bracket.
Connect the hot (red) and cold (blue) tub
filler hoses to the correct water supply
nipples.
Thread the mounting brackets up or down
the filler legs as needed, until the tub filler
assembly is level.

INSTALLATION PROCEDURE

Hot
Supply
4
3/8"-9/16"
(10-15 mm)
5-7/8" (150 mm)
Tub
Escutcheon
Tub Filler
Assembly
Lock Nut
Mounting
Bracket
Tub Filler
Hoses
Hot
Supply
1/2" NPT Nipple
Floor
Surface
Cold
Supply
Handshower
Bracket
Cold
Supply
Tub