Frigidaire GLSZ28V8CB4 Guide D'utilisation Et D'entretien page 6

Choosing Centigrade or Fahrenheit (Select Models)
Depending on which temperature standard you prefer to use, you
can set your control panel to display in Centigrade or Fahrenheit. To
change between these standards, press the Mode button.
Making Temperature Adjustments
After running your refrigerator for 24 hours, you can adjust
temperatures as needed. Make your adjustments small and gradual,
allowing time for temperatures to change and stabilize. Refer the
following guidelines for temperature settings.
Temperature Control Range
Warmest
Less Cold
Factory Midpoint
Setting
Colder
Coldest
Temperature Adjustment Guide
If Refrigerator compartment
is too warm
If Refrigerator compartment
is too cold
If Freezer compartment is
too warm
If Freezer compartment is
too cold
What To Do If The Temperature Displays Flash
If ever you see the temperature displays continuously flashing, it
may indicate that the control system has detected a performance
problem. Call your service representative, who can interpret the
flashing message.
System Monitoring Alarms (Select Models)
The electronic control system continuously monitors your
refrigerator/freezer for temperature consistency, doors left ajar, and
power failures. Variances from normal operating conditions are
Freezer Refrigerator
°F °C °F
6° -14° 47°
0° -18° 37°
-10° -23° 33°
Adjust Refrigerator control one degree
colder by pressing the Down arrow button.
Adjust Refrigerator control one degree
warmer by pressing the Up arrow button.
Adjust Freezer control one degree colder by
pressing the Down arrow button.
Adjust Freezer control one degree colder by
pressing the Up arrow button.
communicated by audible tones and a set of four status indicator
lights.
Note
Each time you make settings on the control panel, a single
audible tone acknowledges your input.
Responding to Alarms (Audible Tones & Indicator Lights)
Your refrigerator's control system can convey the following
information through audible tones and the alarm indicator lights.
Alarm Light
On (light is
off)
°C
8°
3°
1°
Steady
Green
Door Flashing
Ajar Green
High Flashing
Temp Amber
Power Flashing
Failure Amber
6
Tones Condition How To Respond
Alarm system is If freezer and refrigerator
not active while compartments do not
freezer and match your
refrigerator temperature settings in
compartments three hours, expect the
are cooling control system to signal
toward the other conditions. If
current cooling does not
temperature stabilize toward your
settings. current settings call for
assistance, using the
phone number on the
back page of this Use &
Care Guide.
Alarm system is No response required.
active.
Freezer or Close door to disable and
refrigerator door reset alarm.
has been open
for over five
minutes.
Freezer or Press Alarm Reset button
refrigerator to turn off alarm. If
compartment temperatures do not
has been too improve, call for
warm (7.2° C or assistance, using the
higher) for over phone number on the
an hour. back page of this Use &
Care Guide.
A power outage Press Alarm Reset button
was detected. to turn off alarm and
press again to reset.
Check if the power
failure lasted long
enough to affect stored
food temperatures.