Set-Up And Operation; Safety Features - EUROM CK2003T Manuel D'utilisation

Set-up and Operation

Make sure the heater is turned off (mode selector dial to 0W, fan switched to

OFF) and that the thermostat dial is set to maximum (clockwise, as far as it will
go). Now plug into an earthed, correctly functioning 220-240V / 50Hz socket.
The pilot light will switch on.
Turn the mode selector dial to the desired position:

750W =
1250W =
2000W =
The heater will now start to heat the space.
If so desired, the fan (turbo) can be switched on for more rapid and more

effective heat distribution. Set the fan switch to ON. Setting the switch to OFF
switches off the fan.
When the space has reached the desired temperature, turn the thermostat dial

anticlockwise slowly until you hear a click. In this position, the thermostat will
maintain the current temperature by turning the heater on and off for a top-up,
if necessary. If so desired, you can now switch to a lower power level. For
higher temperatures, turn the thermostat dial clockwise, for lower temperatures
anticlockwise.
The heater can also be used as a fresh air fan. To do so, set the thermostat dial

to its maximum position, switch on the fan, but leave the mode selector dial on
0W.
To switch off the heater, first switch off the fan, then turn the mode selector dial

to 0W and unplug.

Safety features

The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. The heater will function as normal once it is
returned to its upright position but you are advised to switch if off, unplug and
check it for damage before using again. Do not use the heater in case of damage or
malfunctioning. Have the appliance inspected/repaired! In case of internal
overheating, the overheating safeguard will switch the heater off. This may
occur if the heater cannot give off enough heat or if it cannot draw in enough fresh
air. As mentioned above, this is generally caused by (partially) covering the heater,
obstructing the air intake and/or outlet grills or installing the heater too close to a
wall or something similar. In case of overheating, switch off the heater and unplug.
Give the heater time to cool down, remove the source of the overheating and use
as normal. If the problem persists or if you have not been able to trace the source
of the overheating, turn the heater off immediately and unplug. Contact a servicing
point to have the heater repaired.
low power heating (750 Watt)
medium power heating (1250 Watt)
full power heating (2000 Watt)
27