PROPAIN EKANO Démarrage Rapide page 8

// MOUNTING THE FRONT WHEEL
Depending on the fork manufacturer, the thru axle must be pushed from the right or left through the dropout of the fork.
1
Remove the thru axle from the fork.
4
Rotate the lever clockwise until there is only a small gap left
between lever head and dropout.
2
1. Remove the transport securing device that is fitted
between the brake pads.
2. Store the transport securing device for future transport
of your bike.
5
1. Close the lever of the thru axle.
2. There must be no gap between lever head and dropout.
→ Closing the lever should require an increasing amount of hand force until the lever is fully closed.
To increase lever tension, open the lever and turn it clockwise. Close the lever to recheck lever tension.
Repeat until the tension is sufficient, then close the lever.
3
1. Put the front wheel into the dropouts of the fork. The
brake rotor must be placed between the brake pads.
2. Open the lever of the thru axle and slide the axle through
the non-drive side (left in the direction of travel) fork
dropouts and hub of the wheel.