PROPAIN EKANO Démarrage Rapide page 5

// USING THE TORQUE WRENCH
1
3 mm
4 mm
5 mm
6 mm
T25
Five different bits are stored in the handle of the torque
wrench:
• 3 mm hexagon socket bit
• 4 mm hexagon socket bit
• 5 mm hexagon socket bit
• 6 mm hexagon socket bit
• T25 socket bit
2
Set zero position:
Before each use of the torque wrench it must be checked
whether the pointer of the scale is set to "0" in the unloaded
state. If not, hold the torque wrench tight and turn the
extension clockwise until the pointer is at "0".
3
Tightening bolts with the torque wrench:
1. Insert the appropriate bit into the extension of the
torque wrench.
2. Set zero position.
3. Turn the bolt clockwise until the pointer indicates the
desired torque value on the scale.
→ Only bolts with right-hand thread can be tightened.
→ The torque wrench covers a range from 0 to
10 Nm. Higher torque values cannot be set with
this torque wrench!