Mounting The Pedals - PROPAIN EKANO Démarrage Rapide

// MOUNTING THE PEDALS

1
R
One of the pedals has a right- and the other a left-hand thread.
Most pedals have the letter "L" and "R" stamped on the end of
the thread. Some pedals come with a groove in the flange of
the left pedal.
1. Slightly grease pedal thread.
2. Turn the left pedal counter-clockwise to screw it into the
thread of the left crank arm and tighten the pedal to a
torque of 35 Nm.
3. Turn the right pedal clockwise to screw it into the thread
of the right crank arm and tighten the pedal to a torque
of 35 Nm.
// MOUNTING THE SADDLE
1
L
Unscrew the bolts of the saddle clamp and remove the upper
clamp.
2
1. Attach the upper clamp to the saddle frame.
2. Adjust the saddle to your personal preferences and
screw in the clamping bolts.
3
Adjust the seat height:
Caution: When adjusting the seat height, the cable of the seat
post must be pushed or pulled in or out the frame. Otherwise
the cable may get damaged!
1. Open the saddle clamp.
2. Push the seat post carefully and slowly into the frame
or pull the seat post out of the frame. At the same time
push or pull the cable in or out the frame.
3. Close the saddle clamp.