Maintenance And Care; Cleaning The Shower Head Faceplate - Franke AQLT0098 Notice De Montage Et De Mise En Service

17. Maintenance and care

The fitting must be checked and maintained at regular intervals, depending on the
water quality and in accordance with the local conditions and rules and regulations
applicable at the site.
Maintain the following components:
• Shower head (see
• Filters (see
• Non-return valve (see
Use suitable cleaning agents which do not attack the fitting in a proper manner and
rinse with water after use. High-pressure cleaners must not be used for cleaning.
Removing the shower panel
For some maintenance tasks, the shower panel must be removed.
Caution!
Do not allow the shower panel to hang by the connecting hoses.
Water connection from above:
17.1 Close the water volume regulators.
a: closed
b: open
17.2 Trigger the fitting.
17.3 Disconnect the water supply.
17.4 Release the screws on the shower panel.
17.5 Unhook the shower panel.
Water connection from rear:
17.6 Release the screws on the shower panel.
17.7 Unhook the shower panel.
17.8 Close the water volume regulators (see
17.9 Trigger the fitting.
17.10 Disconnect the water supply.

18. Cleaning the shower head faceplate

18.1 Release the screw using an Allen key.
18.2 With a screwdriver, carefully lever out the spray faceplate.
18.3 Clean the shower head faceplate.
18.4 Reassemble in reverse order.
Chapter 18.)
Chapter 19.)
Chapter 22.)
Work step 17.1).
- 10 -