Step 7: Backguard Installation (Optional) - Thermador PROFESSIONAL PRO HARMONY PRD305PH Manuel D'installation

Step 7: Backguard Installation
(optional)
Keep Hot Shelf
KHS30QS
Table 2: Backguard Kit Model Numbers
WARNING
Fingers or hands could get pinched when installing the
backguard. Severe injury could result. Use extreme
caution and wear thick protective gloves to avoid
potential laceration to finger or hand while sliding the
backguard down onto the range.
WARNING
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
Installation methods will vary upon need. Before you begin
read these instructions carefully. Observe all local codes
and ordinances.
Backsplash Installation (PA30JBS
The Backsplash must be installed prior to installing an
overhead hood given that the hood shell covers the top
mounting screws of the Backsplash.
To protect against scratches, leave protective film on the
Backsplash until after installation is complete.
If range is already installed, refer to the manufacturer's
instructions to disconnect gas and power supplies. Move
range forward to gain access to rear of unit.
Parts Included
10 – 1'' (25.4 mm)
screws
1 – Backsplash
English 15
Backsplash 9" Low Back
PA30JBS PA30GLBH
)
Tools Needed
Phillips screwdriver or drill
Tape measure
1. Locate and lightly mark wall studs. Wall studs are
usually installed with a 16'' or 24'' (406 or 610 mm)
space on center.
2. The height of the hood will determine the height of the
top edge of the Backsplash. The Backsplash should be
mounted so that the bottom rear edge of the hood
overlaps the Backsplash 1
3. Per each wall stud, use two (2) 1'' (25.4 mm) Phillips
head screws to secure both the top and bottom of the
Backsplash (see Figure 13). Space screws evenly
across top and bottom of Backsplash.
• Due to variable wall stud widths and varying
Backsplash widths, in some cases only one wall
stud may be found at the mounting location.
4. Remove protective plastic.
30" (762 mm)
Figure 13: Backsplash Installation
'' (38 mm).
½