Step 7: Backguard Installation (Optional) - Thermador PROFESSIONAL PRO HARMONY PRG305PH Manuel D'installation

Masquer les pouces Voir aussi pour PROFESSIONAL PRO HARMONY PRG305PH:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Step 7: Backguard Installation
(optional)
Keep Hot Shelf
Backsplash
KHS30QS
Table 1: Backguard Kit Model Numbers
Installation methods will vary upon need. Before you begin
read these instructions carefully. Observe all local codes
and ordinances.
WARNING
Fingers or hands could get pinched when installing the
backguard. Severe injury could result. Use extreme
caution and wear thick protective gloves to avoid
potential laceration to finger or hand while sliding the
backguard down onto the range.
Backsplash Installation (PA30JBS)
Parts Included
10 – 1" (25.4 mm)
screws
1 – Backsplash
The Backsplash must be installed prior to installing an
overhead hood given that the hood shell covers the top
mounting screws of the Backsplash.
To protect against scratches, leave protective film on
Backsplash until after installation is complete.
If range is already installed, refer to the manufacturer's
instructions to disconnect gas and power supplies. Move
range forward to gain access to rear of unit.
WARNING
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
1. Locate and lightly mark wall studs. Wall studs are
usually installed with a 16'' or 24'' (406 or 610 mm)
space on center.
9" Low Back
PA30JBS
PA30GLBH
Tools Needed
Phillips screwdriver or
drill
Tape measure
2. The height of the hood will determine the height of the
top edge of the Backsplash. The Backsplash should be
mounted so that the bottom rear edge of the hood
overlaps the Backsplash 1
3. Per each wall stud, use (2) 1'' (25.4 mm) Phillips head
screws to secure both the top and bottom of the
Backsplash (see Figure 9). Space screws evenly
across top and bottom of Backsplash.
Due to variable wall stud widths and varying
Backsplash widths, in some cases only one wall
stud may be found at the mounting location.
4. Remove protective plastic.
'' (38 mm).
½
30" (762 mm)
Figure 9: Backsplash Installation
English 13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Professional pro harmony prl305ph

Table des Matières