Cleaning, Care, Maintenance; Cleaning, Care & Maintenance; How Often Should The Various Parts Be Cleaned; Cleaning The Pressure Cooker - GSW EASY CLICK 822091 Mode D'emploi

Caution: Take care to prevent the water jet from
hitting the pressure control valve 9 or the safety
valve 5, as water might otherwise get inside the
pan and dilute your food.
Your new pressure cooker is easy to maintain. In
order to enjoy your pressure cooker for a long
time, please ensure you always observe the
following cleaning instructions.
7.1 How often should the various parts be
cleaned?
Activity Fre-
quency
Clean base 8 After each
use
Clean pressure When dirty "7.2 Cleaning the
control valve 9
Clean lid 2 After each
use
Clean sealing After each
ring 7 use
Replace When
sealing ring needed,
1 x year

7.2 Cleaning the pressure cooker

Caution! Never use harsh or abrasive cleaning
products, as this may damage the pressure
cooker.
Please note: If possible you should clean the
pressure cooker directly after use so that any
leftovers do not dry and stick to the base.
Base (8):
Clean the base 8 after each use:
1. Wash the base with hot water and washing-
up liquid.
26

7. Cleaning, care, maintenance

Chapter
"7.2 Cleaning the
pressure cooker"
pressure cooker"
"7.2 Cleaning the
pressure cooker"
"7.2 Cleaning the
pressure cooker"
Available in
specialist shops
2. Lift lever 4.
Note: as soon as you lift lever 4, a little
residual steam may escape.
3. Remove the lid from the base.
2. Rinse with clean water.
3. Dry the base with a tea towel to avoid any
water marks.
Please note: The base is dishwasher friendly.
pressure control valve (9)
1. Unscrew the fastening bolt for the pressure
control valve 9 by turning it it in an anti-
clockwise direction. Use the key 13 supplied
for this purpose.
2. Lift the pressure control valve 9 up and out.
3. Rinse the pressure control valve with clear,
hot water.
Note: You can also use a small amount of
mild detergent and a very soft brush if
necessary.
4. Clean the lid (see section below).
5. Re-insert the pressure control valve into the
lid.
6. Tighten the fastening bolt for the pressure
control valve 9 by screwing it in a clockwise
direction. Use the key 13 supplied for this
purpose.