Culligan WH-S100-O Guide D'installation Et D'utilisation page 7

8
CAUTION: If water pipes are used to ground
electrical systems, appliances or phones, be
certain to install a jumper wire.
10 WH-S100-O
Ensure the filter housing has been properly
tightened using the housing wrench provided.
Slowly turn on main water supply.
Slowly press red pressure-relief button on top
of filter to release trapped air. Check for leaks.
Open nearest faucet and flush filter cartridge
for 5 minutes.
9
If using optional mounting bracket attach
it to the wall using four mounting screws
(not included).
10 WH-S200-C
Ensure the filter housing has been properly
tightened using the housing wrench provided.
Turn bypass valve to "Filter" mode using wrench,
then slowly turn on main water supply.
Slowly press red pressure-relief button on top
of filter to release trapped air. Check for leaks.
Open nearest faucet and flush filter cartridge
for 5 minutes.
Reset filter life indicator (hold reset button
for 2 seconds).
7