Tools Required - Culligan WH-S100-O Guide D'installation Et D'utilisation

English
PARTS
INCLUDED:
• Filter Housing
• WR-S Housing Wrench
• P5 Filter
• BR-C Mounting Bracket (WH-S200-C Model)
• Filter Life Monitor (WH-S200-C Model)
• Timer Battery (Pre-Installed)
NOT INCLUDED:
• Installation Fittings
• Teflon Tape
®
NOTE: Galvanized fittings must be used for
installation on galvanized pipe.
SPECIFICATIONS
WH-S100-O
Pressure Range:
Temperature Range:
WH-S200-C
Pressure Range:
Temperature Range:
PRECAUTIONS
WARNING: Do not use with water that is microbiologically unsafe or of unknown source/quality without
adequate disinfection before or after the system.
CAUTION: Filter housing must be protected against freezing temperatures, frost, snow, sleet, and ice.
Exposure to these elements can produce cracks and product failures.
CAUTION: The rubber O-Ring provides the water-tight seal between the filter head and the housing.
It is important that the O-Ring be properly seated in the O-Ring groove or a water leak will occur.
CAUTION: This product has a limited service life. We recommend that a record be kept regarding the
date of install and any other performed maintenance. In addition, the entire filter housing should be
routinely inspected for signs of stress marks, cracking, chipping, warping, and discoloration. If this
filtration system shows any of these signs of wear, the entire unit should be replaced immediately.
CAUTION: Clear housings may crack or warp over time causing failure and leakage if exposed to
organic solvents, such as those found in aerosol sprays for cleaning products and insecticides.
• For cold water use only. Do not use on hot water line or in areas where the temperature surrounding
the unit exceeds 100°F.
• Keep out of direct sunlight. UV rays can weaken the integrity of the filter housing, and also promotes
biological growth within the unit.
• Make certain that installation complies with all state and local laws and regulations.
• The contaminants or other substances removed or reduced by the selected cartridge are not
necessarily in your water. Ask your local water municipality for a copy of their water analysis,
or have your water tested by a reputable water testing lab.
• After prolonged periods of non-use (such as during a vacation) it is recommended that the system
be flushed thoroughly. Let water run for 5–6 minutes before using.
• All filter cartridges recommended for use with this system carry a limited service life. Changes in
taste, odor, color, and/or flow of the water being filtered indicate that the cartridge should be replaced.
• Some harmless bacteria may attack cellulose media cartridges. If your cartridge seems to disintegrate
or develops a musty or moldy odor, switch to a synthetic media cartridge or consult the manufacturer.
1-800-721-7360
30 –125 psi (2.1– 8.6 bar)
40 –100°F (4.4 – 37.7°C)
30 –100 psi (2.1– 6.9 bar)
40 –100°F (4.4 – 37.7°C)
MONDAY–FRIDAY

TOOLS REQUIRED

• Pipe Cutter or Hacksaw
• 2 Adjustable Wrenches
• File
• Pencil
OR
OPTIONAL MATERIALS
WH-S100-O
SOLD SEPARATELY:
• BR-O Mounting Bracket
• OR-150 Replacement O-Ring
WH-S200-C
SOLD SEPARATELY:
• OR-150 Replacement O-Ring
2
X2
8:00AM–4:30PM (CST)