Printing Model; Removing Model; Software Detailed Introduction; Cura Software Introduction - Ayce 1289595 Mode D'emploi

4.4. Printing Model

On the operation panel, choose "Print the files in the SD card"→"02▁Thinwall-
Cub.x3g", press OK button to start printing.

4.5. Removing Model

After model is completed with printing, it uses the presented plastic scraper (13) in
accompany with printer, to take the model out along with model edge, or firstly disas-
semble the printing platform and take out model.
(This cube is to check whether the distance between nozzle and build plate is normal.
If the strip is of the same width and the width of the gaps between strips is 3 times of
the width of the strip, it means the distance between nozzle and build plate is
normal.)

5. SOFTWARE DETAILED INTRODUCTION

5.1. Cura Software Introduction

5.1.1. Basic Interface
The figure below displays a typical interface of Cura
AYCE
Red Box is Menu Bar
Blue Box is Printing Parameters Setting Bar
Yellow Box is used to Adjust model, and to check model
Black Box is the operation related to Printing,grey buttons displays it
can't be used temporarily under the current condition.
Green Box is Model Preview
5.1.2. The Preference Menu
Click "File" on the menu bar "Preference", enter the preference menu, as shown
in figure below, it can perform the following setting
189 190
GB