Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONTENTS
1.ATTENTIONS
1.1 ABOUT THE INSTRUCTION BOOK
1.2 SAFETY ATTENTIONS
4.1. LINKED WITH POWER SUPPLY
5.2. REPLICATORG SOFTWARE INTRODUCTION
6. OPERATION PANEL SETTING
6.1. OPERATION PANEL INTRODUCTION
6.2. OPERATION PANEL MENU
6.3. THE COMMON OPERATION ON THE OPERATION PANE
7.1. PRINTER DAILY MAINTENANCE GUIDE
7.2. PRINTING EXTRUDER MAINTENANCE AND REPLACEMENT
8. FREQUENTLY ASKED QUESTIONS AND TROUBLESHOOTING(FAQ)
1. ATTENTIONS
176
1.1 About the instruction book
176
176
This instruction book contains 3D printer's installation, use, maintenance, common
177
problems and other important information. Please read this instruction book
177
carefully before use 3D printer. For 3D printer damage and other damages caused
178
by violation of safety matters and operation procedures given in the instruction
178
book, it will be borne by the user.
180
181
181
1.2 Safety Attentions
182
183
1. In the printing or just after printing of 3D printers, as nozzle temperature reach
186
up to 200°C, it is forbidden to touch the printing head directly at this moment.
186
2. 3D printer is equipped with active air filtration system; it can handle the most
187
irritating gases emitted after heating of filaments in printing. But if printing is
188
needed for long time, please use the printer under the well-ventilated environment.
189
3. As 3D printer is complicated for its structure, if there is fault, please refer to the
189
instruction book to eliminate the faults. If the fault still can't be solved, please
190
contact the after-sales department of company. To the printer maintained by user
190
without authorization, the company would not guarantee maintenance.
199
4. As 3D printer is equipped with high voltage inside, it is forbidden to disassemble
206
the printer by the non-professional staff. To any consequence caused by violation of
206
this matter, it would be borne by users.
207
5. Please use the power cable (4) and Print cable (3) provided by company. Any
208
printer failure and other consequences caused by using the power cable (4) and
215
Print cable (3) provided by third parties , it would be borne by user.
220
6. There is no memory function of 3D printer, when the 3D printer begin to print
223
model must to Remain energized.
7. When the printer is connected to ReplicatorG software to print, avoiding
computer appears hibernation, Otherwise, Printing is interrupted.
175 176
GB
Publicité
Chapitres
Table des Matières
