Assembly Of Filament; Printing Preparation - Ayce 1289595 Mode D'emploi

4.2. Assembly of Filament

Assemble the filament support (2) according to the "Instruction of Filament Support
Setting", and after it's done, find out one end of filament from the material tray (2)
and sent it to the feed pipe at the back board of printer, until the filament thread out
from another end of material pipe.
Open the cover plate on the printer; pull out the filament around 20cm from the
material pipe. Break straight the end of filament, right hand presses down the
handle of nozzle, and left hand holds the filament and plug it into the feed inlet,
insertion depth is about 5cm.
Stuff the excess material filament back to the feeding pipe, and then place the
feeding pipe on the feeding hole.

4.3. Printing Preparation

Take out the SD card (5) presented in accompany with printer, and plug it to the card
slot.
Press down the power button at the rear panel, and start up the printer power
supply.
187 188
GB