Tools Required For Assembly; Rear View; Front View - Agri-Fab 45-03462-131 Notice D'utilisation

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(2) 1/2" wrenches
(1) 9/16" wrenches
(1) 3/4" wrench or adjustable wrench
Before assembling the aerator, lay out all of the parts and
hardware as shown on the previous pages.
Spike points are sharp. Exercise caution when
handling and working near spike disks.
1. Loosen the nuts fastening the four angle brackets and the
two hitch arm mount brackets to the tray. See figure 1.
FIGURE 1
2. Assemble the axle bracket to the outside of the angle
brackets using two 5/16" x 1" hex bolts (D) and 5/16"
nylock nuts (G). The ends of the axle bracket must point
as shown in figure 2. Tighten and then loosen the nuts
1/4 turn.
3. Tighten the nuts fastening the two angle brackets to
the tray.
(D) 5/16" x 1"
HEX BOLT
(G) 5/16" NYLOCK NUT
FIGURE 2
LOOSEN NUTS

FRONT VIEW

REAR VIEW

ENGLISH
4. Assemble the wheels to the axle bracket using a shoulder
bolt (A) and a 3/8" nylock nut (F) for each wheel. Tighten.
See figure 3.
(A) SHOULDER BOLT
FIGURE 3
5. Assemble the hitch mount arms to the outside of the
hitch arm mount brackets at the rear of the tray using
two 5/16" x 1" carriage bolts (E) and 5/16" nylock nuts
(G). Tighten and then loosen the nuts 1/2 turn. See
figure 4.
6. Fasten the hitch mount arms to the outside of the angle
brackets at the front of the tray using two 5/16" x 1" hex
bolts (D) and 5/16" nylock nuts (G). Tighten and then
loosen the nuts 1/4 turn. See figure 4.
7. Tighten the nuts fastening the two angle brackets and
the two hitch arm mount brackets to the tray.
(E) 5/16" x 1"
CARRIAGE BOLT
(G) 5/16" NYLOCK NUT
FIGURE 4
5
(F) 3/8" NYLOCK NUT
REAR VIEW
(D) 5/16" x 1"
HEX BOLT
FRONT VIEW