Tools Required For Assembly - Agri-Fab 45-03201 Notice D'utilisation

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

(2) 7/16" Open End or Box End Wrenches
(2) 1/2" Open End or Box End Wrenches
All loose parts are shown on page 2. Fasteners in the parts
bag are shown full size on page 3.
Remove the hardware pack and all loose parts from the
carton and verify that all the parts and fasteners shown on
pages 2 and 3 are included.
ASSEMBLY OF SWEEPER
Note: Right hand (R.H.) and left hand (L.H.) are determined
from the operator's position while seated on the tractor.
1. (Figure 1) Each brush assembly has one brush retainer
marked with either red or black ink. Lay out the brush
assemblies so that the brush retainers marked with red
and black ink are in the middle and positioned as shown.
OVERLAP BRISTLES
BRUSH RETAINER
MARKED BLACK
2. (Figure 2) Tip the sweeper housing forward until it rests
as shown in figure 3.
ENGLISH
1
BRUSH RETAINER
MARKED RED
2
5
3. (Figure 3) Position the brush assembly with the red
brush retainer as shown and attach it to the brush shaft
using two 1/4" x 1" hex bolts (G) and 1/4" nylock nuts
(I). The brush retainer marked with red ink must be at
the center of the sweeper.
1/4" NYLOCK NUT (I)
BRUSH RETAINER
MARKED RED
4. (Figure 4) Position the brush assembly with the black
brush retainer as shown and attach it to the brush shaft
using two 1/4" x 1" hex bolts (G) and 1/4" nylock nuts
(I). The brush retainer marked with black ink must be
at the center of the sweeper.
BRUSH RETAINER
MARKED BLACK
1/4" x 1"
HEX BOLT (G)
BRUSH RETAINER
MARKED RED
1/4" x 1"
HEX BOLT (G)
1/4" NYLOCK NUT (I)
3
4