Agri-Fab 45-03462-131 Notice D'utilisation page 6

8. Turn the aerator right side up and assemble the front
ends of the hitch arms together using two 5/16" x 1-1/4"
hex bolts (C) and 5/16" nylock nuts (G). Do not tighten
yet. See figure 5.
9. Assemble the two hitch brackets to the top and bottom
of the hitch arms using two 5/16" x 2-1/4" hex bolts (B),
four washers (H) and 5/16" nylock nuts (G). Do not
tighten yet. See figure 5.
10. Assemble the 3/8" hitch pin (J) through the hitch brackets
and secure it with a 1/8" hair cotter pin (I). See figure 5.
11. Tighten the bolts and nuts assembled in step 8.
Tighten the bolts and nuts assembled in step 9.
(C) 5/16" x 1-1/4"
HEX BOLT
(G) 5/16" NYLOCK NUT
FIGURE 5
12. Assemble a hitch arm mount bracket (K) to the axle
bracket using two 5/16" x 1" carriage bolts (E) and 5/16"
nylock nuts (G). Do not tighten yet. See figure 6.
(E) 5/16" x 1"
CARRIAGE BOLT
FIGURE 6
(B) 5/16" x 2-1/4"
HEX BOLT
(J) 3/8" HITCH PIN
(G) 5/16" NYLOCK NUT
(H) WASHER
(I) 1/8" HAIR
COTTER PIN
FRONT VIEW
(G) 5/16" NYLOCK NUT
REAR VIEW
ENGLISH
13. Assemble the lift handle through the tray and attach it
to the hitch arm mount bracket assembled to the axle
bracket. Use a 5/16" x 1" hex bolt (D) and a 5/16" nylock
nut (G). Tighten. See figure 7.
14. Position the hitch arm mount bracket so that there is
side tension on the lift handle when it is locked in the
up position. Tighten the nuts. See figure 7.
15. Assemble the grip (L) onto the end of the lift handle.
See figure 7.
FIGURE 7
6
(L) GRIP
LIFT HANDLE
(D) 5/16" x 1"
HEX BOLT
(G) 5/16" NYLOCK NUT
REAR VIEW