Festool CTL 26 E AC HD Notice D'utilisation D'origine page 14

CTL /M
GB

If necessary, attach the closing slide [1-16] to the
intake opening [1-7][3a], see Chapter 8.1 for
more information.

Insert the filter/disposal bag [8] + [10].

Replace the top section [2-1] and close the lock-
ing clips [2-2].

Connect the suction hose to the intake opening
[1-7].
Installing the accessory box including the tube
holder

Position the accessory box on the top section of
the machine [2-1] and secure with two screws
[2-4].
When not using the tube holder, lift the latches, tilt
the tube holder back and remove [2 b].
An assembled suction tube with floor nozzle can be
inserted in the slot on the accessory box. The adapter
must be positioned correctly [2 a].
6.2 Connecting the mobile dust extractor
WARNING
Risk of injury from tools starting up unexpectedly

Before setting the switch to the "AUTO" or
"MAN" position, make sure that the connected
tool is switched off.
The switch [1-12] serves as an on/off switch.

Insert the plug into an earthed socket.
Pull the plug from the socket when the ma-
chine is not in use and prior to maintenance
and cleaning work.
Switch position "0"
Appliance socket [1-9] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-9] is connected to the power, the
mobile dust extractor starts.
7.5 Volumetric flow monitoring
An acoustic warning signal sounds if the air speed in the suction hose falls below 20 m/s (dust class M).
Possible causes
Value set on the suction power adjuster [1-
13] is too low.
Rotary knob [1-15] not set to the correct
hose diameter.
Suction hose blocked or kinked.
Filter bag full.
Dirty main filter.
14
"Auto" switch position
Appliance socket [1-9] is connected to the power, the
mobile dust extractor starts when the connected tool
is switched on.
6.3 Connecting electric power tools
Risk of injury

Observe the maximum appliance socket con-
nected load (see chapter "Technical data")

Switch off the electric power tool.

Connect the electric power tool to the appliance
socket [1-9].
7 Settings
7.1 Adjusting the hose diameter (dust class M
only) [1-15]
The monitoring devices will measure the air speed in
the extractor hose correctly as a result (see chapter
7.7).
7.2 Adjusting the suction power

Use the rotary knob [1-13].
7.3 Applying the brake

Raise the front of the dust extractor slightly.

Push down the brake [1-5] until it engages into
position.

Actuate the lever [1-4] to release.
7.4 Temperature cut-out
A temperature cut-out switches the mobile dust ex-
tractor off when it reaches a critical temperature to
prevent overheating.

Switch off the mobile dust extractor, allow to cool
for about 5 minutes then switch on again.
 Not possible to switch on: contact Festool service
workshop.
Solution
Set the suction power adjuster to a higher value (see
Chapter 7.2).
Set the knob to the correct hose diameter (see Chapter
7.1).
Remove blockage or kink.
Insert a new filter bag (see Chapter 9.1).
Change the main filter (see Chapter 9.1).
WARNING