Schulthess ProLine WE10 Notice D'installation page 31

Removing the transport securing
device
Before putting the appli ance into service for the first
time, the transport securing device on the rear of the
appliance must be removed. Keep the transport securing
device in a safe place for possible future use (move).
Transport the appliance only with the transport securing
device fitted.
Caution – in the case of slipping there is a risk of injury!
Front
X Unfasten and remove the four hex screws to the left
and to the right of the loading door with a 13 mm ring
spanner.
X Remove the red transport safety devices on both sides
of the door.
X On the left side, install the two oval head screws
supplied in the bag, in place of the hex screws.
31 E
X On the right side, re­install the two previously
r emoved hex screws.
The door will leak, without these four screws!
Rear
X Undo the hexagon­head bolts with a 13 mm ring
spanner until the bolts are able to move freely.
X Remove the hexagon­head bolts with the sleeves.