Rear Panel - YORKVILLE MP8DX Guide De L'utilisateur

DX DX DX DX
MP8 MP8 MP8 MP8

REAR PANEL

REAR PANEL REAR PANEL REAR PANEL
1. A & B SPEAKER OUTPUTS & HEATSINKS 1. A & B SPEAKER OUTPUTS & HEATSINKS 1. A & B SPEAKER OUTPUTS & HEATSINKS 1. A & B SPEAKER OUTPUTS & HEATSINKS
Each of the MP8 's power amplifiers have two 1/4" jacks for speaker connections.
DX
You may connect one 8-Ohm speaker cabinet to each jack (two speaker cabinets) or
a single 4-Ohm speaker to AMP A. AMP B has a 2-Ohm minimum load rating and
can therefore drive up to four 8-Ohm stage monitors, or two 4-Ohm stage monitors.
Connecting two 8-Ohm speakers (i.e.a 4-Ohm load) to either AMP A or AMP B will
not harm the MP8 . If the amp overheats, the built-in thermal protection will cycle
DX
the amplifier on and off until it cools down, usually in a few minutes.
•
Do not obstruct the flow of air around the heatsink fins on the rear of the MP8
as this may cause the power amplifier to overheat and shut off. After the MP8
down, operation will be restored automatically. This should never happen if
adequate ventilation is provided at the back of the unit.
2. AC POWER SWITCH & FUSE 2. AC POWER SWITCH & FUSE 2. AC POWER SWITCH & FUSE 2. AC POWER SWITCH & FUSE
The power switch and fuse are located on the back panel. If you must replace the
fuse, always replace it with the same type - a 12A slo-blo (T6A slo-blo in 220-240V
export models). Do Not replace the fuse with the wrong type or wrap foil around the
old one, as this may cause serious damage. If replaced fuses keep blowing, take the
unit to your Yorkville dealer for service.
DX
cools
DX
7