Digital Effects Processor - YORKVILLE MP8DX Guide De L'utilisateur

9. POWER LED & THE SWITCH 9. POWER LED & THE SWITCH 9. POWER LED & THE SWITCH 9. POWER LED & THE SWITCH
The POWER LED lets you know that the MP8
power on/off switch is on the rear panel of the unit.
10. PHANTOM POWER 10. PHANTOM POWER 10. PHANTOM POWER 10. PHANTOM POWER
The PHANTOM power LED indicates that 24 volts of DC phantom power is present
on all the XLR microphone inputs to power condenser microphones. Regular dynamic
mics may be connected while the PHANTOM POWER is activated without encountering
problems. The PHANTOM POWER push-button is located on the rear panel.

DIGITAL EFFECTS PROCESSOR

DIGITAL EFFECTS PROCESSOR DIGITAL EFFECTS PROCESSOR DIGITAL EFFECTS PROCESSOR
1. DIGITAL EFFECTS PROCESSOR SELECT & MODIFY CONTROLS 1. DIGITAL EFFECTS PROCESSOR SELECT & MODIFY CONTROLS 1. DIGITAL EFFECTS PROCESSOR SELECT & MODIFY CONTROLS 1. DIGITAL EFFECTS PROCESSOR SELECT & MODIFY CONTROLS
The SELECT control selects from 16 banks of reverb sounds, delays and other effects. Settings
A through G represent single reverbs or echo delays. Settings H through P are combined or
combo effects where two or more effects are blended together. Simply rotate the SELECT
control to the basic type of effect you prefer. This is a continuous type of control so you may
simply rotate it in either direction to reach the desired setting. Lists of effects banks appear in
this manual and on the front panel of the MP8
Each bank of effects contains 16 individual
effect variations. The MODIFY control selects
each one of these variations. For example, if
bank E (Medium Delays), has been selected,
position 1 will give you 200 milliseconds of
delay, and positions 2 through 16 will give you
progressively longer delays up to 375
milliseconds. Bank P is the exception to this rule.
It consists of sixteen different special effects, such
as pitch shift up, or down, detune flanger, etc.
2. EFFECTS CLIP LED 2. EFFECTS CLIP LED
2. EFFECTS CLIP LED 2. EFFECTS CLIP LED
Situated between the SELECT and MODIFY
controls, the CLIP LED indicates that the
digital processor is receiving an input signal
which is too strong, possibly resulting in
distortion. For maximum dynamic range, the
CLIP LED should flash briefly, but only on
high-energy transients such as loud snare
drum hits. If there is too much CLIP activity,
turn down the channel EFX controls.
3. EFFECTS TABLES 3. EFFECTS TABLES
3. EFFECTS TABLES 3. EFFECTS TABLES
•
See the last page of this manual for the
effect table.
is plugged in and turned on. The AC
DX
.
DX
5