Clarke FOCUS II AUTOSCRUBBER Disk 26 Manuel D'utilisation page 16

ENGLISH
EN
HOW TO PREPARE THE MACHINE
FOR OPERATION
How To Change Or Reverse Bristle Direction On
Cylindrical Machine
To install or reverse bristle direction on the machine, follow
this procedure:
1. Turn the key switch "ON".
2. Put the brush head assembly in the "UP" position.
3. Turn the key switch "OFF".
4. Go to the front of the machine and loosen thumb
screw on brush door. See figure 14.
5. Lower door approximately 1/2 inch and remove brush
door.
6. Remove brush. See figure 15.
7. Inspect brush condition. If damaged or worn, replace
it. Otherwise, turn brush end for end periodically to
reverse bristle direction for better life.
8. Slide brush onto driver or opposite side and rotate
slowly until drive lugs are lined up with brush slots.
Push brush all the way in.
9. Install brush door assembly into brush.
10. Raise door and tighten thumb screw.
11 Repeat for the other brush.
DANGER: Operating a machine that is not
completely or fully assembled
could result in injury or property
damage. Do not operate this ma-
chine unless it is completely as-
sembled.
carefully before operation.
-16-
Inspect the machine
®
Clarke
Operator's Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER
Figure 14
Figure 15
®