■
A level floor with a maximum slope of 1" (25 mm) under
entire washer. Installing the washer on soft floor surfaces,
such as carpets or surfaces with foam backing, is not
recommended.
■
A sturdy and solid floor to support the washer with a total
weight (water and load) of 400 lbs (180 kg).
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage
in low temperatures.
Installation clearances
■
The location must be large enough to allow the washer door
to be fully opened.
■
Additional spacing should be considered for ease of
installation and servicing.
■
Additional clearances might be required for wall, door,
and floor moldings.
■
Additional spacing of 1" (25 mm) on all sides of the washer
is recommended to reduce noise transfer.
■
Companion appliance spacing should also be considered.
Washer Dimensions
51"
(1295 mm)
Recommended installation spacing for custom
undercounter installation
The dimensions shown are for the recommended spacing.
Custom undercounter installation - Washer only
39" min.
(990 mm)
1"
(25 mm)
27"
(686 mm)
38"
(965 mm)
31½"
(800 mm)
1"
27"
(25 mm)
(686 mm)
Recommended installation spacing for recessed or
closet installation, with or without a pedestal
The dimensions shown are for the recommended spacing.
Recessed area or closet installation
34"
(864 mm)
1"
31½"
4"
(25 mm)
(800 mm)
(102 mm)
A
A. Side view - closet or confined area
B. Closet door with vents
*Min. top and bottom air openings for closet door.
Recessed or closet installation - Washer on pedestal
1"
27"
(25 mm)
(686 mm)
A
A. Recessed area
B. Side view - closet or confined area
Recommended installation spacing for recessed or
closet installation, with stacked washer and dryer
The dimensions shown are for the recommended spacing.
2
48 in.
*
2
(310 cm
)
2
24 in.
*
2
(155 cm
)
*Required spacing
3"
(76 mm)
2
48 in.
*
2
(310 cm
)
2
24 in.
*
3"
2
(155 cm
)
(76 mm)
B
18" min.
(457 mm)
1"
1"
31½"
4"
(25 mm)
(25 mm)
(800 mm)
(102 mm)
B
3"* (76 mm)
3"* (76 mm)
1"* (25 mm)
5