Parts Supplied; Before Installing This Product; Installation With The Holder - Pioneer AVIC-F88DAB Manuel D'installation

Installation
! The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation mechanism
to dissipate heat.
Do not cover this area.
! The semiconductor laser will be damaged
if it overheats, so don't install this product
anywhere hot — for instance, near a heater
outlet.

Parts supplied

Parts marked (*) are pre-installed.
This product
Truss head screw
(5 mm × 8 mm)
(6 pcs.)
Trim ring*
Holder*
Flush surface screw
(5 mm × 9 mm)
(6 pcs.)
Extraction Key
(2 pcs.)

Before installing this product

1 Remove the trim ring.
Extend top and bottom of the trim ring out-
wards to remove the trim ring.
1
1 Trim ring
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3 Pull the unit out of the holder.
1
1 Extraction key

Installation with the holder

1 Install the holder into the dashboard.
2 Secure the mounting sleeve by using a
screwdriver to bend the metal tabs (90°)
into place.
1
2
Section
03
27
Engb