Installation Instructions; Installing The Unit - Swegon CLASS UNIT TAC 5 Manuel D'installation Et De Maintenance

2. INSTALLATION INSTRUCTIONS

2.1 Installing the unit


Follow the steps below to install the unit:
Class Unit Installation and maintenance manual

Leave sufficient access to the unit. Make sure it is
possible to access to all the components for
maintenance: fans, controls and filters.

The side of the unit with fresh air inlet must be placed
against a wall. The sizes of the 2 openings to make in
that wall are indicated in the design of the unit.
 The fixation is done thanks to 4 M8 threaded rods
firmly inserted in the roof matching the 4 fixing lugs.
The length of the rods must be enough long to exceed
of at least 2 cm under each support at the desired
height.
The spacing between the holes of the supports is
reported in the unit design.

For the 4 fixing lugs, insert a ring then screw a
bolt of same diameter and thread than the ones
of the rod. Leave the lug exceed at least 1 cm
under the bolt.

Make sure the unit is installed horizontally.

Locate all the 16 mounting brackets of the fairing.

The upper part of the bracket is used to lay the
elements of the fairing.

The hole in the base of the bracket is used to fix
the parts of the fairing.
28