Ibiza Light LMFD-611LED Manuel D'utilisation page 4

The same method for setting the third color.
Any time, when power on, the light will be the chosen color last time (this light
should be set up into slaves first)
3. Operation
The function is to set each light as auto master All intellectual master connected by
DMX signal cord, the PAR64 lights will recognize one as master, others as slaves in 5
to 10 seconds. All slaves in phase with master, but when DMX512 controller
connected, all lights will be controlled by DMX512 controller, and when
disconnection, master/salve synchronization will come back automatically.
Setting method:
When power on, each light will be auto-master.
4. DMX512 operation
1. Install the units in a suitable position (laying or appending).
2. Use standard XLR microphone cable chain your units together via the XLR
connector on the rear of the units. For longer cable runs we suggest a terminator at
the last fixture. This is a 120 ohm resistor between pin1 and pin2 of the XLR
connector.
3. Assign a DMX address to each the unit.
4. Turn on all units' power.
5. Use DMX console to control your units.
Setting method:
When power on, press ESC key, it will only show "001" in digital display screen
without A. press UP and DOWN, and then set the digital you want and press ENTER.
This unit has 5 DMX512 channels：
Channel DMX512 Function
©Copyright LOTRONIC 2012 Page 4