IMG STAGELINE TXS-606HT Mode D'emploi page 10

4.5 Setting the microphone sensitivity
GB
1) Switch on the audio unit (e. g. mixer, amplifier)
connected to the receiver. Speak / sing into the
microphone and set the audio system to such a
volume that the subsequent setting can be
heard well.
2) Press the button SET (6) three times so that the
numerals of "VOL" start flashing.
3) While the numerals keep flashing (5 seconds
after pressing the button SET,
microphone sensitivity with the button
(5). There are four setting levels: -30 dB,
-20 dB, -10 dB, 00 dB
Note: If the numerals stop flashing before you have set
the sensitivity, press the button SET three times again.
If the volume of the microphone signal is too
high or if the signal is distorted, reduce the sen-
sitivity. If the volume of the signal is too low, how-
ever, a poor signal-to-noise ratio results. In this
case, advance the control accordingly.
4) Once the numerals stop flashing, the setting has
been stored.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
10
or ), set the
or
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
6 Specifications
Carrier frequency: . . . . . . 672.000 – 696.975 MHz
Frequency stability: . . . . ± 0.005 %
Transmission power (EIRP)
High: . . . . . . . . . . . . . . 25 mW
Low: . . . . . . . . . . . . . . 2.5 mW
Audio frequency range: . 30 – 18 000 Hz, ± 3 dB
Power supply: . . . . . . . . 2 × 1.5 V battery,
Operating time: . . . . . . . . > 8 h
Ambient temperature: . . . 0 – 40 °C
Dimensions: . . . . . . . . . . ∅ 51 mm × 265 mm
Weight: . . . . . . . . . . . . . . 312 g
Subject to technical modification.
for channels see table
on pages 24 + 25
size AA